Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the rear taillight of the BMW Z4

Model: BMW Z4 E89 - Years 2009-2016
Part: Tail light

In this guide, we will see the steps that will allow us to disassemble and replace the rear taillight and its bulbs of the BMW Z4. First, we open the rear hood and start removing the cover and the lining behind the taillight; then we disconnect the electrical connector of the bulbs and unscrew the screws of the headlight to remove it from the outside, as shown in the video. At this point, if necessary, we replace the bulbs of the headlight or directly the entire rear taillight; then we reassemble the rear headlight on the body, following the video tutorial until the end!

Posted on 4 May 2024 by ScegliAuto

Video tutorial

Related tutorials

Reset Service Light on BMW Z4
Reset Service Light on BMW Z4
BMW Z4 (2002-2008 / E85, E86) In this video, you will see how to reset the "service" light for routine maintenance on the BMW Z4. First, turn off the ignition and put the key in p…
How to reset the tire pressure sensor of the BMW Z4 2003
How to reset the tire pressure sensor of the BMW Z4 2003
BMW Z4 (2002-2008 / E85, E86) When the tire warning light on the instrument panel of your first-generation BMW Z4 (2003) continues to stay on despite there being no puncture, you …
How to reset the service light on the BMW Z4
How to reset the service light on the BMW Z4
BMW Z4 (2009-2016 / E89) The steps to reset the service light of the BMW Z4 are simple and quick to perform independently. The first step is to turn on the instrument panel w…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos