Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Remove the Handle from Your Car

Model: BMW Serie 3 E92, E90, E91 - Years: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013
Part: Handle

See other generations:
Video tutorial

I will show you how to remove the handle from your car. Open the door on the locking side; you will find a hole where you need to center the screw to remove. Loosen the screw with a Phillips screwdriver with a magnetic tip. After that, use your index finger and fingertip to apply pressure and pull the cylinder towards you. Now disconnect the small connector from the cylinder.

Next, using the same procedure, detach the handle by wiggling it left and right while pulling it towards you. Be careful not to break the clips that are in place. Finally, disconnect the connector and the job is done.


Updated on 26 February 2026 by ScegliAuto


Related tutorials

How to Remove the Handle of the BMW 3
How to Remove the Handle of the BMW 3
BMW Serie 3 (1998-2006 / E46) Remove the outer door handle of the BMW? Let's take off the handle from the 3 Series. Move the plastic cover at the top of the door, then unscrew the…
How to Replace the Interior Handle of the BMW 3 Series?
How to Replace the Interior Handle of the BMW 3 Series?
BMW Serie 3 (2012-2019 / F31, F30) To replace the interior handle of the BMW 3 Series, remove the chrome trim located above the handle. This will allow you to loosen the screws underne…
How to Remove the Exterior Handle of a BMW 3 Series
How to Remove the Exterior Handle of a BMW 3 Series
BMW Serie 3 (1998-2006 / E46) Learn how to remove and install the exterior handle located on the door of a BMW 3 Series. Remove the screws on the side of the door (side panel) usi…

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos