Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to change the third brake light bulb on the Chevrolet Silverado MK3

Model: Chevrolet Silverado MK 3 - Years 2014-2018
Part:

In this video, we will see how to change the third brake light bulb on the Chevrolet Silverado MK3, which is located on the top of the pickup cabin: to remove it, we will need a 20mm Torx socket to remove the two screws inside the light, which secure the light to the body. Now we can lift it slightly and pull it away, being careful of the metal clip that is located under the top part. Disconnect the electrical connector. To replace the bulb, use pliers to remove the electrical connectors connected to the bulbs. Remove the burnt bulbs and replace them with new ones, being careful not to touch them with bare hands. Now reattach the electrical connector, the securing clip, and tighten the two 20mm Torx screws. Operation completed.

Posted on 3 June 2025 by ScegliAuto

Video tutorial

Related tutorials

How to replace the third brake light bulbs in a Chevrolet Silverado pickup truck?
How to replace the third brake light bulbs in a Chevrolet Silverado pickup truck?
Chevrolet Silverado (2014-2018 / MK 3) In this tutorial we can see how to replace the third brake light bulbs in the Chevrolet Silverado pickup truck, a very simple and quick operation. Fi…
How to replace the rear light bulb on the Chevrolet Silverado?
How to replace the rear light bulb on the Chevrolet Silverado?
Chevrolet Silverado (2014-2018 / MK 3) In order to replace the rear light bulb of the Chevrolet Silverado, the tailgate of the trunk must be opened so that the screws holding the headlight…
How to reset the service light on a 2013 Chevrolet Silverado
How to reset the service light on a 2013 Chevrolet Silverado
Chevrolet Silverado (2007-2014 / MK 2) Performing the reset of the service light on a 2013 Chevrolet Silverado vehicle is a very simple operation that can be done in a few easy steps. The …

Other guides you may be interested in

Installation of Upgraded Intercooler Radiator with Pipes

Lift the vehicle on suitable axle stands, remove the front wheels, and then the front bumper and grille. Proceed to remove the front headlights; drain the coolant, remove the intercooler radiator and the hoses connecting it to the intake system. Position the new intercooler radiator in the grille, temporarily securing it with cable ties, and mark with a marker the part of the metal that needs to be removed to allow the new hoses to pass through. Cut the marked portion of metal and apply a gasket to the edge. Remove the inner cover of the bumper and position it near the radiator to identify any interfering parts to eliminate: again, apply a gasket to the edge of the cut. Create brackets for securing the new radiator and proceed with the installation of the connecting pipes from the radiator to the intake, shaping and connecting them appropriately. Finally, reassemble the bumper, headlights, and grille.

Watch the video!


by ScegliAuto

More videos