Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset and Repair the LPG Level Sensor on Chevrolet Matiz

Model: Chevrolet Matiz MK 1 - Years 1998-2010
Part: Warning light – error code

In this short video tutorial, you will learn how to reset and repair the LPG level sensor on a Chevrolet Matiz, as well as on other vehicles with the same gas system. First, open the rear boot and remove the floor panel to access the gas tank; then, remove the cover by unscrewing the screws to access the pipes and pressure reducer, as shown in the video. At this point, locate the LPG level sensor wires and disconnect the electrical connector to reset the control unit; then reconnect the connector and check the gas level!

Updated on 13 April 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

Replacing the Fuel Pump on the Chevrolet Matiz
Replacing the Fuel Pump on the Chevrolet Matiz
Chevrolet Matiz (1998-2010 / MK 1) This guide shows you how to remove and replace the fuel pump on the second series Chevrolet Matiz. First, access the rear of the vehicle and start by…
How to Change the Fuel Injectors of the Chevrolet Matiz
How to Change the Fuel Injectors of the Chevrolet Matiz
Chevrolet Matiz (1998-2010 / MK 1) In today's tutorial, you will learn how to remove and replace the fuel injectors of the petrol Chevrolet Matiz. First, open the bonnet and start by r…
How to change the radiator reservoir of the Chevrolet Matiz yourself.
How to change the radiator reservoir of the Chevrolet Matiz yourself.
Chevrolet Matiz (1998-2010 / MK 1) On the Chevrolet Matiz, the replacement of the radiator reservoir is performed with the engine cold and the engine compartment well-lit. First, disco…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos