Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Chevrolet
    3. :
  3. Captiva
    4. : How do you replace the cabin filter on the Chevrolet Captiva?

Chevrolet Captiva - Video tutorial

Model: Chevrolet Captiva MK 1 - Years 2006-2018
Part: Cabin air filter
Operation: How do you replace the cabin filter on the Chevrolet Captiva?

In order to replace the cabin filter of the Chevrolet Captiva, you need to open the glove box on the passenger side and loosen its screws located in the upper part: this will allow the entire glove box to be removed from its housing. In its back, there will be a small cover, which can be removed by unhooking its clips. Inside there will be the passenger compartment filter, which can be extracted and replaced. Once the new filter has been inserted, it will be possible to close it with its cover and re-install the glovebox.


Posted on 7 March 2024 by ScegliAuto



How to replace a cabin filter on Chevrolet Captiva
Chevrolet Captiva (2006-2018 / MK 1) In this video tutorial we can see how it is possible to replace the cabin filter on Chevrolet Captiva, following some simple steps: the filter must b
Where is the cabin filter located in the Chevrolet Captiva?
Chevrolet Captiva (2006-2018 / MK 1) The pollen filter, also called the cabin air filter, is located, as the name itself indicates, inside the passenger compartment (be careful because t
How to replace the oil filter of the Chevrolet Captiva 2.4L
Chevrolet Captiva (2006-2018 / MK 1) These simple and short steps will show us how to disassemble and replace the oil filter cartridge of the Chevrolet Captiva 2.4L. Along with replacing

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos