Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Chevrolet
    3. :
  3. Silverado
    4. : How to mount an LED reversing lamp on Chevrolet Silverado [USA]

Chevrolet Silverado - Video tutorial

Model: Chevrolet Silverado MK 3 - Years 2014-2018
Part: Rear light bulb
Operation: How to mount an LED reversing lamp on Chevrolet Silverado [USA]

In order to replace the reversing light bulb on the Chevrolet Silverado it is necessary to proceed as follows: open the tailgate, there is a fixing screw on the inside of the light unit. Unscrew this screw to unlock and extract the optical unit, on the rear side of the headlight locate the connectors for the connection of the three lights, the central light is that of the reverse gear. Unhook the bulb by turning it, at which point take the new LED lamp and connect the power supply terminal on the lamp holder. Finally, reposition the lamp and reassemble the optical unit.


Posted on 24 October 2022 by ScegliAuto



How to install LED bulbs in the Chevrolet Silverado pick-up ceiling light
Chevrolet Silverado (2014-2018 / MK 3) To replace the floor light of the Chevrolet Silverado pick-up with LED lights, first of all you need to remove the rear ceiling light, which is fixed
Where are the fuses located for the Chevrolet Silverado 2?
Chevrolet Silverado (2007-2014 / MK 2) Knowing the location of the fuses in your Chevrolet Silverado Mk2 is very important as it allows you to intervene in a targeted and safe manner in ca
How to remove the headrest of the Chevrolet Silverado?
Chevrolet Silverado (2019-2024 / MK 1) Removing the headrest of the Chevrolet Silverado is very simple and fast, let's see how to proceed in this tutorial valid for many other models of th

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos