|
Do it yourself
| |||
| ||||
Replacement of the hood cable of a Citroen C3 MK1
Model: Citroen C3
FC, FN
- Years:
2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009
Video tutorial
In this video we can see how it is possible to replace the hood cable of a Citroen C3 MK1 with that of a bicycle. It is an emergency replacement, also made to have the lowest possible expense, but it works. In fact, for 5.87 Brazilian reais (less than a euro) the repair was carried out. The procedure is simple: first we will remove the old cable, which goes from the release lever inside the cabin to the hood opening mechanism; disconnect the cable from the release lever; it may be necessary to partially remove the panel under the steering wheel to access it. We follow the cable through the engine compartment, disconnecting it from the mounting points. For the installation of the new cable, we follow the path of the old cable, connect it to the hood opening mechanism, pass it through the firewall and connect it to the release lever inside the cabin, then make sure the cable is well tensioned and that the mechanism works, doing some operation tests, before reassembling the panels.
Posted on 26 February 2025 by ScegliAuto
Related tutorials
Citroen C3
(2016-2023 /
SY, SX)
It is important to note that the vehicle shown in the video is a Citroen C3 Aircross, but the content is relevant to the Citroen C3, as the bonnet op…
Citroen C3
(2002-2009 /
FC, FN)
The video presented here shows us the entire release and opening mechanism of the Citroen C3 engine hood. Regarding the aforementioned mechanism, one…
Citroen C3
(2002-2009 /
FC, FN)
The cabin air filter of the first series Citroen C3 is located inside the front hood, specifically behind a small door located above the seal between…
Other guides you may be interested in
|
Frequently Asked QuestionsHow to Remove the Rear Seat of a Hyundai Tucson?
To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.029
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |