Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the ignition cylinder of the Citroen Jumper

Model: Citroen Jumper MK 3 - Years: 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024

See other generations:
Video tutorial

Today's main instructions will show us how to disassemble and replace the ignition cylinder of the Citroen Jumper, as well as the Peugeot Boxer and Fiat Ducato. First, we get on board the cabin and start by removing the plastic cover behind the steering wheel; then we disconnect the electrical connector of the ignition cylinder, unscrewing the screws or removing the rivets to disassemble the entire ignition cylinder.

At this point, we install the new ignition cylinder and steering lock, fixing it properly; consequently, the ignition key will also be replaced.


Posted on 15 September 2025 by ScegliAuto


Related tutorials

How to Bleed the Clutch on a Citroen Jumper
How to Bleed the Clutch on a Citroen Jumper
Citroen Jumper (2014-2024 / MK 3) To bleed the clutch on a Citroen Jumper, open the bleed nipple on the slave cylinder and remove the retaining clip indicated in the video. Slowly pre…
Where are the fuses on board the Citroen Jumper 2?
Where are the fuses on board the Citroen Jumper 2?
Citroen Jumper (2006-2014 / MK 2) The fuses located on board the Citroen Jumper van model 2, which was produced between 2006 and 2014, are situated in a easily accessible position for…
How can I reset the service light on my Citroen Jumper?
How can I reset the service light on my Citroen Jumper?
Citroen Jumper (2006-2014 / MK 2) Resetting the service warning on your Citroen Jumper is a very simple operation. This should only be done after performing the service. First, turn o…

Other guides you may be interested in

    Frequently Asked Questions

    • Jumper 2014-2024 - Where is the inertia switch located on Citroen Jumper? Read answer

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos