Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Citroen
    3. :
  3. C3
    4. : Replacement reverse gear switch Citroen C3

Citroen C3 - Video tutorial

Model: Citroen C3 FC, FN - Years 2002-2009
Part: Reverse gear switch
Operation: Replacement reverse gear switch Citroen C3

Prerequisite: The stop switch is in a typically difficult position to reach. In some car models it may differ slightly from what is described. In the model proposed in this example, it is necessary to access the engine compartment in order to remove and replace it. Required: socket wrench with flexible insert, Phillips screwdriver, flat screwdriver. Remove the pipes that obstruct access to the bottom of the engine compartment (intake pipes or air filter boxes and locate the switch. Disconnect the cable. If necessary, to facilitate extraction, clean everything with compressed air. Using the socket wrench. flexible, hook the switch and unscrew it by turning it to the left Insert the new sensor, screw it in and reconnect it electrically Reposition any tubes removed previously and carry out a test to verify the correct functioning of the device.


Posted on 12 December 2023 by ScegliAuto

This video is currently unavailable

    Frequently Asked Questions

    • C3 2002-2009 - Where is the reverse switch of the Citroen C3? Read Answer
    • C3 2002-2009 - Where is the reverse switch located in the Citroen C3? Read Answer

How to reset the tire pressure warning light on Dacia Sandero?

Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal.

Watch the video!


by ScegliAuto

More videos