Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Dipped Beam Bulb on Citroen C4

Model: Citroen C4 MK 2 - Years 2010-2018
Part: Headlight bulb

With the engine off and the handbrake engaged, lift the bonnet and secure it. Access the rear of the affected headlamp from inside the bonnet, then remove the dipped beam cover by pulling it off by hand, as shown in the video. At this point, disconnect the bulb connector, lift the metal clip, and remove the bulb. It's that simple! Insert the new bulb you purchased and reverse the steps for reassembly, then close the metal clip and reconnect the connector. Finally, refit the round cover and you're done.

Updated on 6 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Front Headlight Bulb on Citroen C4
Replacing Front Headlight Bulb on Citroen C4
Citroen C4 (2004-2010 / MK 1) Replace the damaged bulbs in the front headlight of a Citroen C4. Open the front bonnet and secure it. Remove the plastic cover to access the front h…
Replace Headlight Bulb on Citroen C4
Replace Headlight Bulb on Citroen C4
Citroen C4 (2004-2010 / MK 1) How do you replace the front headlight bulbs? Lift the bonnet to access the headlight bulbs. Remove the inspection cover from the back of the headlig…
Where to Find the Fuses on the Citroën C4?
Where to Find the Fuses on the Citroën C4?
Citroen C4 (2004-2010 / MK 1) On the Citroën C4, the fuses are housed in dedicated fuse boxes installed in the vehicle: this model has two. The first is located in the lower left …

How to Replace the Battery on a Honda Vision 110

To replace the battery on a Honda Vision 110, you need to remove the front fairing of the motorcycle, located directly under the front headlamp. To loosen this panel, unscrew the two screws found at its top, just below the handlebar. Once these screws are loosened, lever under the panel to detach it, gaining access to the battery underneath: this battery must be removed from its housing by unscrewing the fixing screws and disconnecting the power cables, replacing it with a new one.

Watch the video!


by ScegliAuto

More videos