Do it yourself
| ||||
|
Citroen C3 - Video tutorial
Model: Citroen C3
SX, SY
- Years 2016-2023 To replace the car battery, proceed as follows: switch off the engine and pull the bonnet opening lever located below the dashboard on the driver's side. Open the bonnet, the battery is located in the upper part of the engine compartment on the right. Open the hatch above the battery and unscrew the nuts with a socket wrench from the positive terminal, then remove the electric cables. Lift the clamp block and pull it out. Then remove the casing located above the battery by sliding it off. Remove the control unit on the side and the battery cover by lifting them. At that point you have access to the battery itself. Proceed to unscrew and remove the negative clamp. There is a locking tab on the long side of the bottom battery that needs to be pushed sideways to unlock the battery. Then lift the battery, clean the terminals if necessary. Take the new battery and grease the terminals, insert the battery in the housing and lock it again by snapping the tab at the bottom again. After that proceed to refit the negative terminal, refit the battery cover and reposition the control unit and the box with the electrical cables. Finally, reconnect the electric cables and close the upper door.
Posted on 28 October 2022 by ScegliAuto
Other guides that may interest you
|
Frequently Asked QuestionsHandbrake adjustment on Ford EcosportFirst remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.055
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |