Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Citroen
    3. :
  3. Xsara
    4. : How do you replace the clutch cable on a Citroën Xsara?

Citroen Xsara - Video tutorial

Model: Citroen Xsara MK 1 - Years 1997-2006
Part: Clutch
Operation: How do you replace the clutch cable on a Citroën Xsara?

To replace the clutch cable of the Citroën Xsara, you need to open the hood in order to access the components located inside the engine compartment: here you will need to remove both the battery and the air filter box, in order to access the underlying components. This will allow you to locate the end of the clutch cable that is connected to the master cylinder: you will need to disconnect this end. Now you can access the interior of the cabin, by removing the protective panel behind the pedal and disconnecting the clutch cable from the corresponding pedal: in this way the old cable can be removed and replaced with a new one.


Posted on 23 May 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Xsara 1997-2006 - How much does it cost to replace the clutch on the Peugeot Xsara Picasso 2 0 hdi? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos