Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you disassemble the windshield wiper pump in the Fiat Ducato?

Model: Fiat Ducato X290 - Years 2014-2026
Part: Windshield wipers

The pump that is responsible for sending water onto the windshield, so that it can then be washed with the windshield wiper brushes, in the Fiat Ducato is located on the left side of the engine hood, looking at the vehicle from the front and obviously next to the windshield washer fluid reservoir. Disassembling it is not complicated, as shown in the video guide attached here, the inlet and outlet tubes of the aforementioned fluid must be removed, the electrical power cable connector must be disconnected and finally the locking loop that holds it in place must be unhooked. Installing the new one will involve following the reverse procedure of what was just described.

Posted on 24 August 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Fuel Pump on a Fiat Ducato
How to Remove the Fuel Pump on a Fiat Ducato
Fiat Ducato (2006-2014 / X250) How to remove the fuel pump on a Fiat Ducato. First, disconnect the battery cables, then remove the plastic cap (located inside the cabin). Use a soc…
How to Remove the Windscreen Washer Pump from the Fiat Ducato x250
How to Remove the Windscreen Washer Pump from the Fiat Ducato x250
Fiat Ducato (2006-2014 / X250) This guide explains how to remove and possibly replace the windscreen washer pump on the Fiat Ducato, model x250. The component to be removed, repair…
How to Replace the Windscreen Washer Pump in a Fiat Ducato Van?
How to Replace the Windscreen Washer Pump in a Fiat Ducato Van?
Fiat Ducato (2006-2014 / X250) As shown in this tutorial, replacing the windscreen washer pump in a Fiat Ducato van is a very simple and quick operation. First, open the bonnet and…

Other guides you may be interested in

How to Replace the Battery on a Honda Vision 110

To replace the battery on a Honda Vision 110, you need to remove the front fairing of the motorcycle, located directly under the front headlamp. To loosen this panel, unscrew the two screws found at its top, just below the handlebar. Once these screws are loosened, lever under the panel to detach it, gaining access to the battery underneath: this battery must be removed from its housing by unscrewing the fixing screws and disconnecting the power cables, replacing it with a new one.

Watch the video!


by ScegliAuto

More videos