Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Crankshaft Oil Seal on the Fiat Punto 1.2 8V

Model: Fiat Punto MK 2, 188 - Years 1999-2011

In this video, you will see how to replace the crankshaft oil seal with the engine removed on the Fiat Punto 188 1.2 8 valves (second series); the oil seal replacement can also be done with the engine mounted in the vehicle by removing the driveshaft, crankshaft pulley, and various drive belts. Start by removing the oil seal from its seat using pointed pliers; then clean the area thoroughly and lubricate the new oil seal. At this point, insert it straight into the seat and tap with a block until it is correctly seated!

Updated on 19 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Camshaft Oil Seal
Replacing the Camshaft Oil Seal
Fiat Punto (1999-2011 / MK 2, 188) When assembling the engine, it is always advisable to use a new set of gaskets and oil seals to avoid unpleasant leaks after installation. The camsha…
How to Remove the Crankshaft Sensor on Fiat Punto
How to Remove the Crankshaft Sensor on Fiat Punto
Fiat Punto (1999-2011 / MK 2, 188) In this video, learn how to remove and replace the crankshaft sensor on a Fiat Punto: lift the front bonnet and secure it with the prop rod. Locate t…
Replacing the Timing Chain on a Fiat Grande Punto 1.3 MultiJet
Replacing the Timing Chain on a Fiat Grande Punto 1.3 MultiJet
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) In this video, you will see the main steps to remove and replace the timing chain on a Fiat Grande Punto 1.3 MultiJet. First, open the bonnet of your…

Other guides you may be interested in

    Frequently Asked Questions

    • Punto 2005-2018 - Where is the inertia switch on the Fiat Grande Punto? Read answer
    • Punto 2005-2018 - How many km does the Fiat Punto run in reserve? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos