Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Doblo
    4. : Replacing the oil and engine oil filter on Fiat Doblò

Fiat Doblo - Video tutorial

Model: Fiat Doblo MK 2, Doblo 2, 263 - Years 2009-2021
Part: Engine oil
Operation: Replacing the oil and engine oil filter on Fiat Doblò

Jack up the vehicle and secure it with jack stands. Raise the hood and unscrew the top oil cap. Place a container under the oil pan and unscrew the drain bolt located under the engine compartment as shown in the video. Collect the oil in the container and dispose of it properly at the ecological islands. While the oil is running out, get a special filter wrench like the one used in the video and unscrew the oil filter which is still in the lower part of the engine compartment. Close the drain hole and fill in new oil from the upper hole, then put the cap back on.


Posted on 12 March 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Doblo 2009-2021 - How much engine oil is needed in the Fiat Doblò 1.6 Multijet? Read Answer
    • Doblo 2000-2009 - Why does the engine oil warning light flash red in the Fiat Doblo? Read Answer
    • Doblo 2009-2021 - What to do if the flashing oil light comes on on Fiat Doblo? Read Answer
    • Doblo 2009-2021 - What is the right amount of engine oil for the Fiat Doblo with 1.3 MultiJet engine? Read Answer
    • Doblo 2009-2021 - Why is the engine oil warning light flashing in the Fiat Doblò? Read Answer
    • Doblo 2009-2021 - How much engine oil does the Fiat Doblò 1.9 JTD contain? Read Answer
    • Doblo 2009-2021 - What does the flashing oil warning light mean in Fiat Doblò? Read Answer

Replace the steering angle sensor on the Volkswagen Golf 5

When the steering angle sensor malfunction warning light comes on, it may need to be replaced as follows: first remove the steering wheel and the lower steering wheel guard by removing the three fixing screws. The steering sensor is located just below the steering column. To release it you need to have a small screwdriver and insert it into the hole on the front, push the screwdriver all the way down until the clips at the bottom are released. Next, pull down on the back of the card containing the sensor and disengage it from the steering column. At that point take the new card and reposition it, after which proceed backwards to reassemble the various components.

Watch the video!


by ScegliAuto

More videos