Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Boot Light Bulbs on a Fiat Panda 169

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Light bulb

In this video tutorial, you will see how to dismantle and replace the light bulbs in the boot of a Fiat Panda 169. First, access the boot by opening the tailgate and remove the light fittings by detaching them from the rear hooks; then unscrew the fixing screws of the side carpet to access the rear cable. At this point, disconnect the electrical connector of the bulb and remove it, replacing it with a new one. The video demonstrates how to replace them with LED bulbs for better lighting inside the boot.

Updated on 30 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove and Replace the Third Brake Light on a Fiat Panda 169
How to Remove and Replace the Third Brake Light on a Fiat Panda 169
Fiat Panda (2003-2012 / 169, MK 2) Today, you will see the instructions that will allow you to remove and replace the third brake light, or replace the bulbs, on a Fiat Panda 169, seco…
How to Change the Rear Light Bulbs on Fiat Panda 2 (169)
How to Change the Rear Light Bulbs on Fiat Panda 2 (169)
Fiat Panda (2003-2012 / 169, MK 2) In this short video, you will learn how to remove the rear light and replace the bulbs on a Fiat Panda second series, specifically the 169. Start by …
How to Replace the Knob Bulbs on a Fiat Panda
How to Replace the Knob Bulbs on a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) Before you begin, sit in the driver's seat of your Fiat Panda. Start by prising off and removing the two smaller knobs by pulling them towards you. N…

    Frequently Asked Questions

    • Panda 2003-2012 - How many reversing lights are there on the Fiat Panda? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos