Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Panda
    4. : How to replace the Fiat Panda gearshift gaiter

Fiat Panda - Video tutorial

Model: Fiat Panda MK 2, 169 - Years 2003-2012
Part: Gearshift gaiter
Operation: How to replace the Fiat Panda gearshift gaiter

To replace the Fiat Panda gearshift gaiter, proceed as follows: start by pulling the gear knob upwards, remove the knob spring, pull from the bottom remove the gearshift gaiter, take the new boot, put the upper part of the old headset, the old plastic support and put it by inserting it in its seat, put back the spring of the gear knob and the knob itself. In the video the lower plastic of the headset is also changed. We proceed by putting the reverse gear (when the cap is still removed) and unscrewing the screws with a Phillips screwdriver, we remove the plastic by levering both on the right and on the left and we clean the area of the removed plastic. We put the new plastic back by screwing the screws, we also put some grease in the gear lever, we reassemble the cap, the spring and the knob.


Posted on 1 April 2024 by ScegliAuto

    Frequently Asked Questions

    • Panda 2003-2012 - How much does the Fiat Panda gearshift gaiter cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos