Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Fuel Pump from the Fiat Stilo 1.9 JTD?

Model: Fiat Stilo MK 1 - Years 2001-2010
Part: Fuel pump

In this video tutorial, you will see how to remove and replace the fuel pump of the Fiat Stilo with a 1.9 JTD engine. First, climb into the rear and start by removing the rear seat by lifting it upwards; then remove the fuel pump cover. At this point, disconnect the diesel pipes, followed by the electrical connector of the fuel level sensor; all that’s left is to unscrew the pump collar to remove it and replace it with the new one, applying the reverse procedure of disassembly!

Updated on 7 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Air Conditioning on a Fiat Stilo 1.9 JTD
Fiat Stilo (2001-2010 / MK 1) In this video tutorial, you will see the instructions to reset the air conditioning on a Fiat Stilo 1.9 JTD by following these steps; this procedure …
How to Replace the Fuel Cap Lanyard on a Fiat Stilo
How to Replace the Fuel Cap Lanyard on a Fiat Stilo
Fiat Stilo (2001-2010 / MK 1) In today's video, you will see how to reattach the lanyard on the fuel cap of the Fiat Stilo. This tutorial also applies to other models equipped wit…
How to Replace the Fuel Filter on a Fiat Stilo?
How to Replace the Fuel Filter on a Fiat Stilo?
Fiat Stilo (2001-2010 / MK 1) Replacing the fuel filter on a Fiat Stilo is an extremely simple and quick operation. First, wait for the engine to be completely cold. Open the bonn…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos