Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Fiat
  4. :
  5. Ducato
  6. : How to reset the Fiat Ducato service

Fiat Ducato - Video tutorial

Model: Fiat Ducato X290 - Years 2014-2023
Part: -board computer
Operation: How to reset the Fiat Ducato service

In today's video you will see how to turn off the service warning light in the Fiat Ducato. First enter the vehicle and take the driver's seat. Now turn the key and turn on the instrument panel. Hold down the accelerator and simultaneously pump the brake pedal at least 6 times. Keep the accelerator pressed for about 30 seconds, then release the pedal and turn off the vehicle. Wait about a minute and then restart your Ducato. The service light will flash for a few seconds and then everything will be ok. The parameter will now be reset to 45,000 km or 24 months before turning on again.


Posted on 22 April 2024 by ScegliAuto



Resetting the service light on a Fiat Ducato
Fiat Ducato (1981-1993 / MK 1) Hello! Today we will explain how to reset the service light on a Fiat Ducato. It is important to remember that this step should only be done after pe
How to reset the service light on the Fiat Ducato
Fiat Ducato (2006-2014 / X250) Today's information will show us how to reset the maintenance service light for the engine oil change on the Fiat Ducato. First, get in the vehicle a
How to reset the Fiat Ducato service
Fiat Ducato (2014-2023 / X290) In today's video we see how to reset the service deadline in the Fiat Ducato. This tutorial also applies to the Peugeot Boxer and Citroen Jumper twin

Other guides that may interest you

    Frequently Asked Questions

    • Ducato 2014-2023 - What does the AdBlue warning light on the Fiat Ducato indicate? Read Answer
    • Ducato 2014-2023 - What does the AdBlue warning light on the Fiat Ducato indicate? Read Answer

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos