Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Ignition Coils on a Fiat 500 Abarth?

Model: Fiat 500 312 - Years 2007-2022
Part: Ignition coil

To replace the ignition coils on a Fiat 500 Abarth, open the bonnet to access the components inside. You will need to loosen the retaining rings that connect the pipes to the engine block, moving them completely. This will allow the panel to be removed, and you can then unscrew the screws that secure the coils in their housings. Next, disconnect the connectors, and the coils can be removed to be replaced with a new spare part. After installation, secure the coils, reconnect them, and cover everything with the panel.

Updated on 18 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Where is the OBD port located on the 2017 Fiat 500 Abarth?
Fiat 500 (2007-2024 / 312) Being able to independently locate the OBD port inside your 2017 Fiat 500 Abarth can be difficult as the OBD port in question is well hidden inside t…
How to Replace the Front Headlight Bulb of the Fiat 500 Abarth
How to Replace the Front Headlight Bulb of the Fiat 500 Abarth
Fiat 500 (2007-2024 / 312) Replacing a front headlight bulb on a Fiat 500 Abarth follows the same steps used for replacing a front headlight bulb on a Fiat 500 or Fiat 500 L. T…
Removing the Boot Handle of a Fiat 500 Abarth
Removing the Boot Handle of a Fiat 500 Abarth
Fiat 500 (2007-2021 / 312) In this video tutorial, you will learn how to remove the boot handle of a Fiat 500 Abarth, as well as the standard Fiat 500. First, open the boot lid…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos