Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Doblo
    4. : Replacing the resistor of the passenger compartment fan of the Fiat Doblò

Fiat Doblo - Video tutorial

Model: Fiat Doblo 223, MK 1, Doblo 1 - Years 2000-2009
Operation: Replacing the resistor of the passenger compartment fan of the Fiat Doblò

In today's video tutorial we will see the instructions on how to remove and replace the resistor of the passenger compartment fan of the Fiat Doblò. First of all we get on board the car, on the passenger side, and begin to disassemble the plastic cover that we find under the glovebox, in order to access the passenger compartment fan and its resistance; after which we disconnect the electrical connector and remove the fan resistor, disconnecting it and replacing it with the new one, as shown in the video. At this point we are going to reassemble the resistance and the plastics of the dashboard!


Posted on 10 May 2024 by ScegliAuto

    Frequently Asked Questions

    • Doblo 2000-2009 - What problems does the Fiat Doblò 1.9 MultiJet have? Read Answer
    • Doblo 2009-2021 - What do the red warning lights on the Fiat Doblo indicate? Read Answer
    • Doblo 2022-2029 - Where is the EGR valve located in a Fiat Doblò? Read Answer
    • Doblo 2022-2029 - Where is the reverse gear switch on the Fiat Doblò? Read Answer
    • Doblo 2000-2009 - Where is the fire barrier of a Fiat Doblo located? Read Answer
    • Doblo 2009-2021 - How much does the new Fiat Doblò methane cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos