Do it yourself
Frequently asked questions about cars and motorcycles

How to Bleed the Cooling System of the Fiat Panda

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Antifreeze coolant

In this video, you will learn how to bleed the coolant from the Fiat Panda. Perform all operations with the engine off and cold. Start by unscrewing the cap of the expansion tank. Now, loosen the clamp on the cooling hose and before removing the hose, place a container to collect the liquid that will spill out. Once done, reattach the hose and proceed to top up with new coolant; it is advisable to remove the side cap from the tank and when the liquid starts to come out, close it and pause momentarily. Open the other bleed screw to let out all the air. Now close it and start the engine to check for proper operation.

Updated on 30 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Fiat Panda (2003-2012 / 169, MK 2) Follow these steps to bleed and replace the radiator fluid on a Fiat Panda 169 second series, with a 1.2 petrol engine. First, open the bonnet of you…
Fiat Panda (2003-2012 / 169, MK 2) Learn how to replace the thermostat on a Fiat Panda. Lift the front bonnet of the car and locate the parts to remove to access the thermostat. Remove…
Fiat Panda (2003-2012 / 169, MK 2) Is the radiator fluid due for replacement? Let’s look at draining the coolant on a Panda. Lift the car on a jack, disconnect the radiator hose at the…

    Frequently Asked Questions

    • Panda 2012-2026 - Where to put water in the Fiat Panda? Read answer
    • Panda 2003-2012 - Where are the water bleed valves of the Fiat Panda? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos