Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install or Replace Parking Sensors on the Fiat Bravo 2

Model: Fiat Bravo Bravo 2 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014
Part: Parking sensors

See other generations:
Video tutorial

In today's tutorial, you will learn how to install or replace the parking sensors on the second series Fiat Bravo. First, open the boot lid and start by removing the rear bumper, unscrewing all the screws and removing the upper plastic panel; then, if it is a new installation, make new holes for the sensors.

Replace the old sensors with new ones if your vehicle is already equipped with them; finally, wire the camera to the display, following the video to the end!


Updated on 8 June 2026 by ScegliAuto


Related tutorials

How to Remove and Replace the Air Vents of the Fiat Bravo
How to Remove and Replace the Air Vents of the Fiat Bravo
Fiat Bravo (2007-2014 / Bravo 2) Follow this guide for step-by-step instructions to remove and replace the air vents of the Fiat Bravo. First, get inside the vehicle and start by rem…
How to Remove the Radio from a Fiat Bravo
How to Remove the Radio from a Fiat Bravo
Fiat Bravo (2007-2014 / Bravo 2) How to replace the damaged stereo in a Fiat Bravo? Here’s how to remove it. Use the original metal keys to remove the stereo from the Fiat Bravo. Ins…
How to Replace the Mirror Glass on the Fiat Bravo
How to Replace the Mirror Glass on the Fiat Bravo
Fiat Bravo (2007-2014 / Bravo 2) The video shows the exact procedure to dismantle and replace the mirror glass on a Fiat Bravo second model. First, fully extend the mirror outwards a…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos