Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Doblo
    4. : How do you change the engine oil on a Fiat Doblò?

Fiat Doblo - Video tutorial

Model: Fiat Doblo MK 1, Doblo 1, 223 - Years 2000-2009
Part: Engine oil
Operation: How do you change the engine oil on a Fiat Doblò?

In order to change the engine oil of the Fiat Doblò you have to go and lift the car using a jack or a bridge, so that you can access the lower part of the vehicle. Below that, you will find the oil tank drain plug, which will need to be opened so that the old oil can be contained in a container. After all the old oil has drained out, you will need to close the drain plug and lower the car to access the engine compartment. Here, the new oil with the right characteristics must be poured into the tank, which must then be closed with the appropriate cap.


Posted on 9 December 2022 by ScegliAuto

    Frequently Asked Questions

    • Doblo 2009-2021 - How much engine oil is needed in the Fiat Doblò 1.6 Multijet? Read Answer
    • Doblo 2000-2009 - Why does the engine oil warning light flash red in the Fiat Doblo? Read Answer
    • Doblo 2009-2021 - What to do if the flashing oil light comes on on Fiat Doblo? Read Answer
    • Doblo 2009-2021 - What is the right amount of engine oil for the Fiat Doblo with 1.3 MultiJet engine? Read Answer
    • Doblo 2009-2021 - Why is the engine oil warning light flashing in the Fiat Doblò? Read Answer
    • Doblo 2009-2021 - How much engine oil does the Fiat Doblò 1.9 JTD contain? Read Answer
    • Doblo 2009-2021 - What does the flashing oil warning light mean in Fiat Doblò? Read Answer

Replace the steering angle sensor on the Volkswagen Golf 5

When the steering angle sensor malfunction warning light comes on, it may need to be replaced as follows: first remove the steering wheel and the lower steering wheel guard by removing the three fixing screws. The steering sensor is located just below the steering column. To release it you need to have a small screwdriver and insert it into the hole on the front, push the screwdriver all the way down until the clips at the bottom are released. Next, pull down on the back of the card containing the sensor and disengage it from the steering column. At that point take the new card and reposition it, after which proceed backwards to reassemble the various components.

Watch the video!


by ScegliAuto

More videos