Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : How to remove the Fiat 500L STOP headlight to replace the bulb.

Fiat 500 - Video tutorial

Model: Fiat 500 500 L - Years 2012-2023
Part: Tail light
Operation: How to remove the Fiat 500L STOP headlight to replace the bulb.

In this video tutorial we can see how it is possible to remove the STOP headlight of the Fiat 500L to replace the bulb. The material needed: an 8-inch Allen key, a Phillips screwdriver, a flashlight and a P21 / 5W bulb. We lift the tailgate and turn on the flashlight to make us light. Remove the plastic grid; once the grille has been removed, we have to remove the two cylinders that hold the headlight in place with the Allen wrench size 8. Once the two cylinders have been unscrewed, we need to remove the headlight from the outside. At this point we must disconnect the connector, pulling the tab outwards, then remove the connector. Place the lighthouse on a surface, then with the Phillips screwdriver, we must unscrew the screws to access the compartment where there are the bulbs of the bulbs. We take out the bulb block and then we go to remove the old bulbs, then we have to replace the old bulbs with the new ones; reassemble all the parts, proceeding backwards.


Posted on 26 October 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 500 2012-2023 - How to replace the brake light bulb on the Fiat 500l? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos