Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : How to install the cone filter on a Fiat 500S.

Fiat 500 - Video tutorial

Model: Fiat 500 - Years 2007-2022
Part: Air filter
Operation: How to install the cone filter on a Fiat 500S.

Let's see how to install the cone air filter, which is more sporty and gives a particular "sound" even to a small engine car. These filters are now very popular, and you can find them on all e-commerce platforms. We have selected this code on Amazon: B0948ZK597, it costs 17.52 euros including delivery, but there are also cheaper ones. Then, if you want to spend more, you'll find a whole world of options! As we can see in the video, the installation is very simple. First of all, we need to remove the filter box that we want to take off, just unscrew two screws and disconnect the air duct. Remove the filter box. Insert the cone filter into the air duct, tighten the clamp, cone filter installed!


Posted on 13 August 2023 by ScegliAuto

    Frequently Asked Questions

    • 500 2012-2021 - Where is the cabin filter located in the Fiat 500? Read Answer
    • 500 2014-2022 - Where is the Fiat 500x cabin air filter located? Read Answer
    • 500 2014-2022 - Costs for replacing engine and passenger compartment air filters for Fiat 500 x mjt? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos