Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : Replacement of the starter motor of the Fiat 500 Multiair

Fiat 500 - Video tutorial

Model: Fiat 500 - Years 2007-2022
Part: Starter motor
Operation: Replacement of the starter motor of the Fiat 500 Multiair

Today we will see the main steps that will allow us to disassemble and replace the starter motor of the Fiat 500, with a gasoline Multiair engine. First, we open the engine hood of our car and start by disassembling and removing the battery, disconnecting both terminals; we unscrew the battery holder screw to remove it as well, using a socket wrench with an extension, disconnecting the electrical wiring underneath. At this point, we unscrew the fastening screws of the starter motor, disconnect the electrical connector to remove it and replace it with the new one!


Posted on 10 November 2023 by ScegliAuto

    Frequently Asked Questions

    • 500 2007-2022 - What problems does the Fiat 500 starter have? Read Answer
    • 500 2012-2023 - How to solve the problem of the start & stop not working on the Fiat 500L? Read Answer
    • 500 2007-2021 - How much does it cost to replace the ignition lock of the Fiat 500? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos