Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Fuel Pump

Model: Ford Mustang MK 4 - Years 1994-2004
Part: Pump

The fuel pump is located inside the tank: to replace it, you must remove the tank as it is not accessible from inside the cabin like in most cars. Disconnect the negative terminal of the battery, drain the tank by siphoning the fuel, remove the trim around the filler cap, and lift the vehicle on a ramp to access the mounting brackets. Disconnect the connector located nearby and the pipe at the mounting pin of the bracket, also disconnect the filter and the supply and return pipes. At this point, place a jack under the tank for support and proceed to remove the brackets; once the tank is removed, disconnect the pipe connected to the flange of the pump and then unscrew the mounting pins of the flange to remove it and extract the pump from the tank. Finally, insert the new pump and reverse the procedure for installation.

Updated on 10 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the light bulbs of the Ford Mustang.
How to replace the light bulbs of the Ford Mustang.
Ford Mustang (2005-2014 / S197, MK 5) Today we will replace the rear light bulb of the 2006 Ford Mustang. To perform the bulb replacement, we need to open the trunk and using a T30 wrench…
Replacement of the Starter Motor
Replacement of the Starter Motor
Ford Mustang (2005-2014 / S197, MK 5) The starter motor is essential as it allows you to start your car's engine. You can replace it without necessarily needing a mechanic's help. To begi…
How to Replace the Remote Battery on a Ford Mustang?
How to Replace the Remote Battery on a Ford Mustang?
Ford Mustang (2015-2023 / MK 6, S550) To replace the battery in the Ford Mustang remote, pry open the groove that separates the two halves of the remote casing: once opened, you can locat…

Other guides you may be interested in

How to reset the tyre pressure warning light on the Suzuki Jimny?

To reset the tyre pressure warning light on the Suzuki Jimny, first inflate the tyres to the pressure value indicated on the corresponding sticker: this is located at the bottom of the driver's door pillar. Once the tyres are inflated, insert the ignition key and turn on the instrument panel: select the screen that indicates the tyre pressures, checking that the values change. After a few seconds, the tyre pressure warning light will automatically turn off.

Watch the video!


by ScegliAuto

More videos