Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Replacing Spark Plugs

Model: Ford Focus MK 2, Focus 2 - Years 2004-2011
Part: Spark plugs

It is recommended to perform this maintenance with the engine cold to safely handle the components in question. Once the cover is removed, blow out the ignition coil seats with compressed air to prevent dirt from entering the cylinders. Then disconnect the connectors from the ignition coils, unscrew the respective fixing screws, and extract the coils complete with the connectors. Apply the appropriate anti-oxidant lubricant to the connectors, clean the spark plug seats, and proceed with the disassembly; install the new spark plugs without exceeding the tightening torque and refit the connectors.

Updated on 11 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Instructions for Replacing Spark Plug Leads
Instructions for Replacing Spark Plug Leads
Ford Focus (1998-2004 / MK 1) Wear and damage of spark plug leads is a common issue in older vehicles. In any case, a fault in the lead can compromise proper combustion, affecting…
Replacing the Glow Plugs on the Ford Focus 1.6 TDCI
Replacing the Glow Plugs on the Ford Focus 1.6 TDCI
Ford Focus (2004-2011 / MK 2, Focus 2) The following steps will show you how to remove and replace the glow plugs on the Ford Focus 1.6 TDCI, following the instructions below. First, open …
How to Replace the Spark Plugs on a Ford Focus
How to Replace the Spark Plugs on a Ford Focus
Ford Focus (2004-2011 / MK 2, Focus 2) Before you can start, open the bonnet of your Ford Focus. Begin by pulling the spark plug leads upwards to remove them. Once you have removed all the…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos