Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : How to remove the starter motor of the Ford Focus

Ford Focus - Video tutorial

Model: Ford Focus MK 1 - Years 1998-2004
Part: Starter motor
Operation: How to remove the starter motor of the Ford Focus

In today's video tutorial we will see the steps that will allow us to disassemble and replace the starter motor of the Ford Focus. First of all we open the bonnet of our car and begin to disconnect the battery terminals; after which we remove the intake sleeve and disconnect the electrical connector of the throttle position sensor, as shown in the video. At this point we raise the car and unscrew the fixing screws of the starter motor; then let's remove it and replace it with the new one, with the original spare part, following the video tutorial until the end!


Posted on 27 August 2022 by ScegliAuto

    Frequently Asked Questions

    • Focus 2018-2025 - Where is the Ford Focus starter motor located? Read Answer
    • Focus 2004-2011 - Where is the starter motor located in the Ford Focus mk2? Read Answer
    • Focus 2011-2018 - What is the price of the starter motor of the Ford Focus 1 6 tdci? Read Answer
    • Focus 1998-2004 - What problems does the starter motor of the Ford Focus have? Read Answer
    • Focus 2018-2025 - Where is the starter motor located on my Ford Focus 1.6 Tdci? Read Answer
    • Focus 2004-2011 - How much is the starter motor of the Ford Focus 1.8 TDCI? Read Answer
    • Focus 1998-2004 - How much does the 2004 Ford Focus starter motor cost? Read Answer
    • Focus 1998-2004 - Where is the starter motor of the Ford Focus 1.8 TDCi located Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos