Do it yourself
| ||||
|
Ford Mondeo / Fusion - Video tutorial
Model: Ford Mondeo / Fusion
MK 1
- Years 1993-2000 Before proceeding with the disassembly of the starter motor, it is advisable to disconnect the battery in order to avoid any short circuits; in order to access the starter motor, which is located above the gearbox, it is necessary to remove the intercooler and turbine hoses as well as the engine air filter container; at this point disconnect the power cables and position the car on suitable car stands in order to access the car floor: to complete the disassembly of the starter motor, it is necessary to remove the muffler from the exhaust manifold and the turbine support bracket ; it is therefore possible to complete the disassembly of the motor by unscrewing the fixing pins and extracting it from its seat, always from the lower part of the engine compartment; then proceed backwards to install the new motor (you can opt for a regenerated one) by first applying the centering bushings.
Posted on 12 August 2023 by ScegliAuto
Replacing the starter motor
Ford Mondeo / Fusion (1993-2000 / MK 1) The starter motor is an essential electrical component that allows you to start the car. If your car stops starting, one of the causes could be the s
Ford Mondeo starter motor replacement
Ford Mondeo / Fusion (2000-2007 / MK 2) Is the starter motor damaged and we don't know how to remove it? Let's see how it disassembles on a Mondeo. We disconnect the cables from the car bat
Check starter motor operation
Ford Mondeo / Fusion (2000-2007 / MK 2) Once the starter motor has been removed and fixed in a vice, it is possible to check its operation using a battery. In any case, once disassembled, i Other guides that may interest you
|
How to reset the tire warning light on Toyota Yaris CrossTo reset the tire pressure warning light, first we check the pressure of all the wheels, then we turn on the instrument panel without turning on the car, we press the button with the arrow to the right until we go to the gear screen; with the arrow down we go to the word "vehicle settings" and press the "ok" button for a few seconds to confirm; with the arrow down we go to the writing "TPWS setting", press the "ok" button to confirm; with the arrow down we go to the wording "wheel identification and position", press the "ok" button for a few seconds to confirm; at this point the warning light will flash slowly 4 times and then it will stay on for about ten minutes, if after 10 minutes the warning light goes out the operation is finished and we can turn off the instrument panel (it may take a few kilometers for a total reset), otherwise, if the warning light does not go off, it is advisable to go to the assistance service. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.095
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |