Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : Where is the engine oil pressure sensor located in the Ford Focus?

Ford Focus - Video tutorial

Model: Ford Focus MK 2, Focus 2 - Years 2004-2011
Part: Engine oil
Operation: Where is the engine oil pressure sensor located in the Ford Focus?

In this video we can see where the engine oil pressure sensor is located in the Ford Focus. This is a very important element for the correct functioning of the vehicle and, like any other device, is subject to wear. As shown, the sensor is located in the lower area of the engine, exactly to the left of the oil filter which is positioned towards the passenger side. To replace it, simply disconnect the connector, unscrew the two fixing bolts and assemble the spare following the reverse procedure. Make sure there is no oil leak.


Posted on 17 November 2022 by ScegliAuto

    Frequently Asked Questions

    • Focus 2011-2018 - What is the amount of engine oil needed for replacement on a Ford Focus 1.6 TDCi 90hp? Read Answer
    • Focus 2018-2025 - What is the right amount of engine oil for the Ford Focus 1.5 EcoBlue? Read Answer
    • Focus 2018-2025 - Why does the "change engine oil" light come on on the Ford Focus? Read Answer
    • Focus 2011-2018 - How much engine oil do you need for a Ford Focus 1.5 TDCi 120 hp? Read Answer
    • Focus 2004-2011 - How many liters of engine oil go on a Ford Focus 1.8 tdci? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos