Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : How to replace the turbine on Ford Focus 1.6 TDCI

Ford Focus - Video tutorial

Model: Ford Focus MK 3 - Years 2011-2018
Part: Turbine
Operation: How to replace the turbine on Ford Focus 1.6 TDCI

We see below the main instructions that will allow us to disassemble and replace the turbine of the Ford Focus 1.6 TDCI. First we open the bonnet of our car and start disassembling and removing the intake manifold; we then remove the turbo sleeve, unscrewing the screws of the metal clamps, and disassemble the metal bulkhead located above the turbocharger, as shown in the video. At this point we disconnect the manifold from the turbine and unscrew the additional fixing screws to remove it, replacing it with the new one, following the video tutorial to the end!


Posted on 10 April 2023 by ScegliAuto

    Frequently Asked Questions

    • Focus 2004-2011 - How much does it cost to replace the turbine in the Ford Focus 1.6 TDCi? Read Answer
    • Focus 2011-2018 - Why does the Ford Focus turbine not work? Read Answer
    • Focus 2004-2011 - How many km do you revise the turbo of the Ford Focus 16 tdci? Read Answer
    • Focus 1998-2004 - How much does the 2003 Ford Focus intake pipe cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos