Do it yourself
| ||||
|
Ford Fusion North America - Video tutorial
Model: Ford Fusion North America
MK 2
- Years 2013-2020 Today's guide will show us how to disassemble and replace the fuel pump of the Ford Fusion, as well as the Mondeo. In order to access the fuel pump, it will be necessary to remove the tank from the frame by lifting the vehicle and unscrewing all the fastening screws; then we disconnect the fuel lines. At this point, we remove the pump ring and disconnect the electrical connector, removing the pump or float from the tank; we then replace the fuel pump with the new one, using the original replacement, and finally reassemble the fuel tank!
Posted on 31 December 2023 by ScegliAuto
Other guides that may interest you
|
How to reset the TPMS light of the Volkswagen Polo 2011The orange tire light indicates the presence of one or more tires with an inflation pressure below the recommended limit. All this is easily solved by inflating them correctly or replacing them in the event of a puncture. After carrying out these operations it is necessary to reset the warning light and therefore also the sensor in order to have new reading data. All you have to do is start the car ignition and then fully open the glove compartment on the passenger side. Locate the two buttons in the right corner and press "Set". At this point the reset is complete and you can turn off the ignition. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.013
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |