Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the SYNC Module in the Ford Fusion?

Model: Ford Fusion North America MK 1 - Years 2006-2012
Part: Checks and maintenance

In this tutorial, you will see how to remove the SYNC module in the Ford Fusion, useful if you need to replace it. First, go to the rear seat. Then, pry off the cover of the center tunnel, using a plastic trim tool if necessary. Once done, locate the module, remove the mounting screws using a 7mm hex wrench, and detach it from the bracket. At this point, disconnect the side connectors, connect them to the replacement part, and install it by following the reverse procedure.

Updated on 20 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to remove the car radio in the Ford Fusion?
How to remove the car radio in the Ford Fusion?
Ford Fusion North America (2013-2020 / MK 2) In this tutorial we can see how to dismantle the car radio in the Ford Fusion, an extremely simple and fast operation. First of all, make sure that t…
How to disassemble the door panel on a Ford Fusion
How to disassemble the door panel on a Ford Fusion
Ford Fusion North America (2013-2020 / MK 2) To disassemble the door panel on a Ford Fusion, here are the general steps you can follow. Open the door of your Ford Fusion. Remove any covers or in…
Where is the fuse box of the Ford Fusion located?
Where is the fuse box of the Ford Fusion located?
Ford Fusion North America (2006-2012 / MK 1) If you don't know where the fuse box is located inside the cabin of your first-generation Ford Fusion, don't worry because with the following guide y…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos