Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Front Door Panel of the GMC Yukon

Model: GMC Yukon Gmt900 - Years 2007-2014
Part: Door trim panel

Let's go through the instructions to remove and replace the front door panel of the GMC Yukon. First, open the front door of your vehicle and start removing the plastic caps located on the panel itself; then, unscrew all the screws found underneath and on the sides, as shown in the video. Next, pry the sides with something thin to detach the panel; disconnect the handle cable and remove the window switch panel by unplugging the electrical connector underneath to completely remove the door panel!

Updated on 11 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Bumper Grille on the GMC Yukon
How to Replace the Front Bumper Grille on the GMC Yukon
GMC Yukon (2021-2026 / Gmt1yc) In this guide, discover the steps to remove and replace the front bumper grille on the GMC Yukon, following the instructions below. First, open the h…
How to Replace the Front Brake Pads on a GMC Yukon
How to Replace the Front Brake Pads on a GMC Yukon
GMC Yukon (2007-2014 / Gmt900) To replace the front brake pads on a GMC Yukon, lift the vehicle with a jack so that the front wheel is off the ground. At this point, loosen the bol…
How to Replace the Gas Springs on a GMC Yukon Trunk
How to Replace the Gas Springs on a GMC Yukon Trunk
GMC Yukon (2000-2006 / Gmt800) To replace the gas springs on the GMC Yukon trunk, open the rear hatch to access the support springs inside. To remove these springs, unscrew the bol…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos