Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Remote Battery in the Holden Colorado 7?

Model: Holden Colorado 7 MK 2 - Years 2011-2024
Part: Key

Replacing the dead battery in the remote for the Holden Colorado 7, as shown in this tutorial, is an extremely simple and inexpensive task. First, get a small flathead screwdriver and a replacement CR2032 battery. Start by pressing the metal button on top and extending the emergency key, then pry open the rear cover using the gap just created. Once you have access to the battery, proceed with the replacement, ensuring the new battery is installed in the correct orientation.

Updated on 25 May 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

How to Enter the Radio Code in a 2009 Holden Colorado?
How to Enter the Radio Code in a 2009 Holden Colorado?
Holden Colorado 7 (2008-2012 / MK 1) Have you disconnected the radio from the battery and now it is locked? No problem, to use it again, simply enter the radio code, a 4-digit PIN provid…
Where are the fuses located in the Holden Colorado?
Where are the fuses located in the Holden Colorado?
Holden Colorado 7 (2008-2012 / MK 1) The fuses of the Holden Colorado are located inside the appropriate fuse boxes that are installed on the vehicle: in this type of vehicle, two can be…
How to Remove the Radio from the Holden Colorado 7
How to Remove the Radio from the Holden Colorado 7
Holden Colorado 7 (2011-2024 / MK 2) In today's tutorial, you will learn how to remove and replace the factory radio of the Holden Colorado 7 by following the instructions below. First, …

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos