Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installation of Rear Spoiler

Model: Honda CR-V MK 3 - Years 2007-2012
Part: Body

First, remove the caps at the end of the rubber strips along the edges of the roof, near the rear bonnet.
Use the supplied drilling template to mark the points where you will drill holes on the upper strip of the bonnet (rotate the template to mark from the other side).
Drill the holes first with a 3 mm bit and then enlarge them with an 8 mm bit.
Position the spoiler and mark the point for the central hole: first with the 3 mm bit and then with the 11 mm bit.
Apply the rubber washer around the newly drilled hole and the supplied nut; apply the other rubber washer to the central hole of the spoiler and position it on the bonnet, applying the respective fixing nuts.
Finally, apply the central fixing screw and the supplied cap.

Updated on 3 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Installation of Front Spoiler
Installation of Front Spoiler
Honda CR-V (2012-2017 / MK 4) Lift the vehicle on a hydraulic lift to facilitate the installation of the air deflector under the front bumper. First, remove the two pressure clips…
Installing a Rear Spoiler
Installing a Rear Spoiler
Honda CR-V (2012-2017 / MK 4) First, open the tailgate until it is securely held open. Using a plastic bodywork spatula, detach the plastic trim along the upper edge of the bonnet…
Installing a Rear Spoiler
Installing a Rear Spoiler
Honda CR-V (2007-2012 / MK 3) After purchasing the necessary kit, start marking, using the appropriate template, the points where the fixing holes will be drilled. Protect the bod…

How to Open the Bonnet of a Renault Megane if the Lever is Broken?

If the lever that unlocks the bonnet of the Renault Megane is broken or not functioning, there is an emergency procedure to unlock the mechanism: remove the right front grille located at the top of the bumper. Once the grille is removed, you can locate the actuator mechanism: by pulling the spring in this position, you can unlock the actuator, allowing you to lift the bonnet and access the components located inside the engine compartment. You can then close the bonnet simply by lowering it.

Watch the video!


by ScegliAuto

More videos