Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Honda
    3. :
  3. Cr V
    4. : Bodywork

Honda CR-V - Bodywork

Honda CR-V (2012-2017 / MK 4)
Installing the rear panel protector on the Honda CR-V
Let's see how to install this beautiful chrome protection on the rear trunk panel of the Honda CR-V. It is an accessory that can be purchased ready for …read all…
Posted on 28 December 2022 by ScegliAuto
Honda CR-V (2007-2012 / MK 3)
How to remove and reinstall the lower splash bar
To remove and reinstall the anti-splash bar located in the lower part of the car, it will be necessary to have a lift and erect it in order to work better and …read all…
Posted on 21 September 2023 by ScegliAuto
Honda CR-V (2007-2012 / MK 3)
Windscreen wiper panel replacement
After opening the hood, remove it to work more comfortably, now go and remove the bolts that block the wipers, in this way, by making a few movements to take …read all…
Posted on 19 September 2023 by ScegliAuto
Honda CR-V (2007-2012 / MK 3)
Hood replacement and repair
After lifting the hood, mark the height to which the hood supports are bolted, now you can proceed to unscrew the bolts that support it to the car body, making …read all…
Posted on 19 September 2023 by ScegliAuto
Honda CR-V (2007-2012 / MK 3)
Body bar replacement and maintenance
Remove the wipers by unscrewing the bolt under the plastic cap, remembering which one is on the driver's side, now also remove the rubber gasket and all the …read all…
Posted on 18 September 2023 by ScegliAuto
Honda CR-V (2012-2017 / MK 4)
Rear spoiler installation
First we need to open the tailgate to the point that it stays open safely. Using a plastic spatula for body repairers, unclip the plastic covering along the …read all…
Posted on 5 July 2023 by ScegliAuto
Honda CR-V (2007-2012 / MK 3)
Side steps installation instructions
Raise the car on a lift and unhook the plastic covers on both the right and left, in the central area of the car, by removing the plastic clips. On the same …read all…
Posted on 1 July 2023 by ScegliAuto
Honda CR-V (2007-2012 / MK 3)
Rear spoiler installation
First remove the plugs at the end of the rubber bands along the edges of the roof, near the rear hood. Use the drilling template supplied to mark the points …read all…
Posted on 29 June 2023 by ScegliAuto
Honda CR-V (2012-2017 / MK 4)
Application of door moldings
Carefully clean the surface of the doors in correspondence with the strip on which to glue the moldings. Apply the reference templates by matching the upper …read all…
Posted on 29 June 2023 by ScegliAuto
Honda CR-V (2007-2012 / MK 3)
Application of door moldings
To apply the door moldings, carefully clean the surface of the doors at the point where the moldings are to be glued, removing any residue of dirt. Therefore, …read all…
Posted on 29 June 2023 by ScegliAuto
Airbags (2) Shock absorbers (7) Antenna (1) Car stereo (19) Anti roll bar (2) Roof Rack Bars (3) Battery (10) Coil (1) Arm (6) Spark plugs (4) Bodywork (10) Wheel rim (1) Key (14) Locking the trunk (1) Timing belt (4) -board computer (20) Checks and maintenance (49) Dashboard (5) Gearshift gaiter (1) Bearing (2) Mass air flow sensor (2) Differential (2) Brake discs (4) Headlight (8) Tail light (4) Fog lights (5) Air filter (14) Cabin air filter (14) Petrol filter (2) Diesel filter (5) Oil filter (4) Grille (2) Accessory Kit (20) Light bulb (9) Headlight bulb (8) Rear light bulb (2) Interior lights ceiling light bulb (5) Antifreeze liquid (2) Dashboard light (2) License plate light (4) Third brake light (2) Handle (2) Muffler (1) Engine (1) Window motor (1) Starter motor (1) Gear oil (2) Engine oil (13) Door panel (7) Windshield (1) Front bumper (3) Rear bumper (1) Brake pads (3) Hydraulic pistons (1) Tires (9) Gear Shift Knob (2) Pump (4) Fuel pump (2) Push button (2) Instrument cluster (16) Radiator (3) Passenger compartment heating radiator (1) Fuse box (12) Seat (1) Crankshaft RPM sensor (2) Parking sensors (2) Lock (1) Suspensions (1) Outside rearview mirror (7) Interior rearview mirror (2) Manufacturer's coat of arms (1) Windscreen wipers (12) Engine head (3) Transmission (1) Central tunnel (1) Valve (2) EGR valve (1) Interior blower (1) Side window (1) Steering wheel (6)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos