Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Honda
  4. :
  5. Cr V
  6. : Push button

Honda CR-V - Push button

Honda CR-V (2007-2012 / MK 3)
How to change the steering wheel instrument button on a Honda CR V

Let's see in this video how to remove the flying button. Let's get a plastic spatula and go and unhook the cap behind the steering wheel. We unclip the power …read all…
Posted on 26 September 2023 by ScegliAuto
Honda CR-V (2007-2012 / MK 3)
Honda Cr V cruise control switch assembly replacement

To replace the Honda Cr V cruise control switch unit, proceed as follows: 1) Disconnect the battery. 2) Remove the cover on the internal base of the steering. …read all…
Posted on 25 September 2023 by ScegliAuto

Airbags (2) Shock absorbers (7) Antenna (1) Car stereo (19) Anti roll bar (2) Roof Rack Bars (3) Battery (10) Coil (1) Arm (6) Spark plugs (4) Bodywork (10) Wheel rim (1) Key (14) Locking the trunk (1) Timing belt (4) -board computer (20) Checks and maintenance (49) Dashboard (5) Gearshift gaiter (1) Bearing (2) Mass air flow sensor (2) Differential (2) Brake discs (4) Headlight (8) Tail light (4) Fog lights (5) Air filter (14) Cabin air filter (14) Petrol filter (2) Diesel filter (5) Oil filter (4) Grille (2) Accessory Kit (20) Light bulb (9) Headlight bulb (8) Rear light bulb (2) Interior lights ceiling light bulb (5) Antifreeze liquid (2) Dashboard light (2) License plate light (4) Third brake light (2) Handle (2) Muffler (1) Engine (1) Window motor (1) Starter motor (1) Gear oil (2) Engine oil (13) Door panel (7) Windshield (1) Front bumper (3) Rear bumper (1) Brake pads (3) Hydraulic pistons (1) Tires (9) Gear Shift Knob (2) Pump (4) Fuel pump (2) Push button (2) Instrument cluster (16) Radiator (3) Passenger compartment heating radiator (1) Fuse box (12) Seat (1) Crankshaft RPM sensor (2) Parking sensors (2) Lock (1) Suspensions (1) Outside rearview mirror (7) Interior rearview mirror (2) Manufacturer's coat of arms (1) Windscreen wipers (12) Engine head (3) Transmission (1) Central tunnel (1) Valve (2) EGR valve (1) Interior blower (1) Side window (1) Steering wheel (6)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos