Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Honda
    3. :
  3. Cr V
    4. : Fog lights

Honda CR-V - Fog lights

Honda CR-V (2007-2012 / MK 3)
How to install fog lights on the Honda CR-V.
Today we will see, in this short and simple guide, how to install the front fog lights on the Honda CR-V, following the instructions below. First of all, we …read all…
Posted on 16 July 2023 by ScegliAuto
Honda CR-V (2012-2017 / MK 4)
How to replace the front fog light bulbs of the Honda CR-V.
In this guide, we will see the instructions on how to disassemble and replace the front fog light bulbs of the Honda CR-V, following these simple steps. First, …read all…
Posted on 16 July 2023 by ScegliAuto
Honda CR-V (2012-2017 / MK 4)
Replacing the front fog light on Cr V
Replacing the spotlight of the Cr V? Let's see how to remove the fog light in the front bumper. We remove the cover plastics of the fog light with a …read all…
Posted on 19 December 2023 by ScegliAuto
Honda CR-V (2007-2012 / MK 3)
Installation of front fog lights
The installation is quite complex and requires at least two hours of work. Remove the engine cover by removing the seven clips. Remove the screws under the …read all…
Posted on 2 July 2023 by ScegliAuto
Honda CR-V (2007-2012 / MK 3)
Installation of front fog lights
Remove the engine cover by removing the seven clips. Remove the screws under the caps and the bumper fixing clips located in the fenders and under the body. …read all…
Posted on 29 June 2023 by ScegliAuto
Airbags (2) Shock absorbers (7) Antenna (1) Car stereo (19) Anti roll bar (2) Roof Rack Bars (3) Battery (10) Coil (1) Arm (6) Spark plugs (4) Bodywork (10) Wheel rim (1) Key (14) Locking the trunk (1) Timing belt (4) -board computer (20) Checks and maintenance (49) Dashboard (5) Gearshift gaiter (1) Bearing (2) Mass air flow sensor (2) Differential (2) Brake discs (4) Headlight (8) Tail light (4) Fog lights (5) Air filter (14) Cabin air filter (14) Petrol filter (2) Diesel filter (5) Oil filter (4) Grille (2) Accessory Kit (20) Light bulb (9) Headlight bulb (8) Rear light bulb (2) Interior lights ceiling light bulb (5) Antifreeze liquid (2) Dashboard light (2) License plate light (4) Third brake light (2) Handle (2) Muffler (1) Engine (1) Window motor (1) Starter motor (1) Gear oil (2) Engine oil (13) Door panel (7) Windshield (1) Front bumper (3) Rear bumper (1) Brake pads (3) Hydraulic pistons (1) Tires (9) Gear Shift Knob (2) Pump (4) Fuel pump (2) Push button (2) Instrument cluster (16) Radiator (3) Passenger compartment heating radiator (1) Fuse box (12) Seat (1) Crankshaft RPM sensor (2) Parking sensors (2) Lock (1) Suspensions (1) Outside rearview mirror (7) Interior rearview mirror (2) Manufacturer's coat of arms (1) Windscreen wipers (12) Engine head (3) Transmission (1) Central tunnel (1) Valve (2) EGR valve (1) Interior blower (1) Side window (1) Steering wheel (6)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos