Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Honda
    3. :
  3. Fit
    4. : Honda Fit headlight bulb replacement

Honda Fit - Video tutorial

Model: Honda Fit GE - Years 2007-2012
Part: Headlight bulb
Operation: Honda Fit headlight bulb replacement

Let's see in this guide the steps that will allow us to remove and replace the Honda Fit headlight bulb. First of all, let's move to the side of the car, accessing the front wheel arch; then we remove the plastic screw to access the rear of the light, removing the plastic cover of the bulb, as shown in the video. At this point we disconnect the electrical connector to remove and replace the bulb with the new one, of the right type (in this case of type H4); we make the electrical connection and reassemble everything!


Posted on 1 June 2024 by ScegliAuto



How to replace the front headlight bulb of the Honda Fit 2012
Honda Fit (2007-2012 / GE) Replacing the front headlight bulb of your second generation Honda Fit (2012) is really simple and you can complete the operation by following the st
How to replace the rear bulbs on the Honda Fit?
Honda Fit (2020-2024 / GR3, GR1, GR4, GR2, GR5, GR6, GS1, GR7, GR8, GR9) The replacement of the rear bulbs of the Honda Fit is done through a special access from inside the trunk. There is therefore no need to disassemble
How to replace the headlight on Honda FIT
Honda Fit (2007-2012 / GE) Let's see in this guide the steps on how to disassemble and replace the Honda FIT headlight, following the instructions below. First of all we open t

Other guides that may interest you

How do you replace the horn on the Citroà «n Berlingo?

In order to replace the horn on the Citroà «n Berlingo, the vehicle must be raised so that the screws that secure the left front wheel can be loosened and removed completely. Once this wheel has been removed, it will be possible to access the screws that secure the internal cover of the corresponding wheel arch: this will have to be detached and it will be possible to access the components inside, including the horn. This will need to be disconnected from its connector and removed from its holders, so that it can be replaced with a new spare part.

Watch the video!


by ScegliAuto

More videos