Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Clutch Cable on a Hyundai i10 MK1

Model: Hyundai I10 PA, MK 1 - Years 2007-2013

In today's video, you will see the steps to disassemble and replace the clutch cable on a first series Hyundai i10. First, get inside the vehicle and remove the plastic panel above the pedals by unscrewing the fixing screws; then open the engine bonnet and remove the entire intake duct along with the air filter box, as shown in the video. At this point, disconnect the clutch cable located near the gearbox; remove the clutch pedal, then slide out and replace the cable from the engine compartment!

Updated on 16 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Adjust the Clutch Pedal on Hyundai I10
Hyundai I10 (2007-2013 / PA, MK 1) In this video tutorial, you will see the main instructions for adjusting the clutch on a Hyundai I10, as well as on other models from the manufacture…
Clutch Replacement on the Hyundai I10 1.1 Petrol
Clutch Replacement on the Hyundai I10 1.1 Petrol
Hyundai I10 (2007-2013 / PA, MK 1) In this video tutorial, discover the steps to perform a DIY clutch change on the first series Hyundai I10 with a 1.1 petrol engine. First, lift the v…
How to Adjust the Clutch Cable on the Hyundai I10
How to Adjust the Clutch Cable on the Hyundai I10
Hyundai I10 (2007-2013 / PA, MK 1) Below are the main instructions that will allow you to adjust the clutch cable on the Hyundai I10. First, open the bonnet of the vehicle and start lo…

Other guides you may be interested in

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos