Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. Getz
    4. : Swing arm head replacement

Hyundai Getz - Video tutorial

Model: Hyundai Getz MK 1 - Years 2002-2011
Part: Arm
Operation: Swing arm head replacement

In case of breakage of the ball head of the oscillating arm of the suspension, it is possible to evaluate whether to replace the entire arm or to proceed with the repair of the same by installing a new head: this operation necessarily requires the use of a press and a series of pieces of tube. by the appropriate diameter; then lift the car, remove the front wheel and the nut fixing the head to the hub support; use the special extractor to remove the head from its seat and complete the disassembly of the swinging arm; remove the rubber cap, remove the seeger ring and position the arm under the press to extract the old head and insert the new one; then apply the seeger ring, the rubber cap and proceed backwards for installation on board the car.


Posted on 2 September 2023 by ScegliAuto



How to replace the bushings of the front arm.
Hyundai Getz (2002-2011 / MK 1) Place the car on the deck and raise it to a comfortable height for working on it. Remove the front wheel corresponding to the arm of which to replace
Disassembly of the front arm bushing of a Hyundai Getz
Hyundai Getz (2002-2011 / MK 1) Let's see the disassembly of the front arm bushing of a Hyundai Getz. First we put the car on a column bridge and loosen the wheel pins with a telesc
Hyundai Getz silent block replacement
Hyundai Getz (2002-2011 / MK 1) Today we will see the main steps on how to remove and replace the silent blocks (they serve to minimize vibrations and noise) of a Hyundai Getz. We l

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos