Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the clutch pump of the Iveco Daily.

Model: IVECO Daily MK 4 - Years: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017
Part: Clutch

See other generations:
Video tutorial

Today we will explain how to replace the clutch pump of the Iveco Daily. To carry out this procedure, you need to purchase a compatible or original clutch pump, a 10mm and 13mm socket wrench, pliers, a container for fluid, brake fluid, bleeding tubes, star and flathead screwdrivers, and gloves.

Open the hood and locate the clutch pump, which is on the driver's side between the pedal and the firewall. Using pliers, remove the retaining clip of the rod that connects the pedal to the pump.

Place a plastic container under the pump and loosen the fittings to allow the fluid to drain into the container once the screws are removed. From the engine compartment, unscrew the screws that secure the pump to the firewall using the 10mm wrench and gently pull out the pump.

Insert the pump back in the same position, securing it with the screws and connecting the hydraulic tubes. Fill the brake fluid reservoir to the maximum level, connecting a small tube to the bleeder screw on the clutch receiver cylinder.

Open the bleeder screw and close it immediately afterward to prevent bubbles from forming. Repeat this process until only clean fluid comes out of the tube without air. Reattach the retaining clip of the rod to the pump pedal, then get inside the vehicle and check while driving for any leaks near the fittings.


Posted on 15 January 2026 by ScegliAuto


Related tutorials

Fuse box diagram for an Iveco Daily
IVECO Daily Through this very short video tutorial, you can see the diagram of the main fuse box for an Iveco Daily, a model produced from 2000 to 2006. The diag…
Where is the OBD2 port on the Iveco Daily 2009?
Where is the OBD2 port on the Iveco Daily 2009?
IVECO Daily (2006-2020 / MK 4) If you want to access the OBD2 port located inside your Iveco Daily (2009 model), simply follow the steps described below. First, enter the vehicle a…
Where to Find the Fuse Box of the Iveco Daily 2007
IVECO Daily If you own an Iveco Daily MK2 (2007) and want to find out where the fuse box is located, just read this new mini guide carefully and put into practic…

Other guides you may be interested in

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos