|
Do it yourself
| |||
| ||||
How to Replace the Spare Wheel on a Jeep Cherokee
Model: Jeep Cherokee
XJ, MK 2
- Years 1984-2001
This guide shows how to replace the flat wheel with the spare on a Jeep Cherokee. The owner's manual explains the procedure in detail, including the location of tools and jacking points for the vehicle. The first step is to secure the vehicle and, if on the road, use warning devices as stated in the Highway Code. At this point, retrieve the jack and spare wheel. Depending on the model, these two items may have slightly different locations; however, they are located in the boot. The spare wheel may be placed under the rear compartment protection panel, and extraction is similar to other cars, or it may be located under the chassis. In the latter position, it must be lowered using the screw at the bottom of the boot. Now you can extract the wheel from under the vehicle and prepare to replace it. Loosen the bolts on the damaged wheel and lift the car at the designated points. Finish unscrewing the wheel bolts and replace it with the new one. Tighten the bolts until secure but not fully; lower the car and tighten the bolts in a criss-cross pattern. The use of the spare wheel is restricted to the journey to a specialist centre to remount the original wheel, and exceeding a certain speed limit indicated on the spare wheel rim is not recommended.
Updated on 17 April 2026 by ScegliAuto
This video is currently unavailable
Related tutorials
Jeep Cherokee
(2013-2023 /
KL, MK 5)
In this brief and simple guide, follow step-by-step instructions to remove and replace the wheel with the spare on the Jeep Cherokee fifth generation…
Jeep Cherokee
(1984-2001 /
XJ, MK 2)
To replace the front shock absorber on a Jeep Cherokee, loosen the bolts securing the wheel corresponding to the shock absorber being replaced. Once …
Jeep Cherokee
(2013-2023 /
KL, MK 5)
Follow the procedure below to remove and replace the front brake pads on a Jeep Cherokee. First, lift the vehicle and remove the front wheel. Next, u…
Other guides you may be interested in
|
How to Check the Oil Level on a Jeep Renegade?
To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.698
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |