Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Renegade
    4. : How to change the engine oil and oil filter on the Jeep Renegade 2.4 MultiAir

Jeep Renegade - Video tutorial

Model: Jeep Renegade - Years 2014-2021
Part: Oil filter
Operation: How to change the engine oil and oil filter on the Jeep Renegade 2.4 MultiAir

Today we will see, in this guide, how to carry out the routine maintenance service of the oil change and the oil filter on the Jeep Renegade 2.4 MultiAir, but also on the MultiJet. First of all we lift the car and start unscrewing the oil vent bolt that we find on the sump, using a socket wrench; then let the old oil drain in a container for about ten minutes. At this point we are going to unscrew the oil filter, which we find next to the oil pan, using the appropriate wrench; then we screw the new one and hand tighten. Finally, let's pour the new oil!


Posted on 14 May 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Jeep Renegade 2014-2023 - Where is the oil filter located on the Jeep Renegade? Read Answer
    • Jeep Renegade 2014-2023 - How much does it cost to change the oil filter in the Jeep Renegade? Read Answer
    • Jeep Renegade 2014-2023 - Where is the oil filter of a Jeep Renegade located? Read Answer
    • Jeep Renegade 2014-2023 - Where is the Jeep Renegade's oil filter located? Read Answer
    • Jeep Renegade 2014-2023 - Where is the Jeep Renegade's oil filter located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos