Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Grand Cherokee
    4. : To reset the oil light on the 2012 Jeep Grand Cherokee.

Jeep Grand Cherokee - Video tutorial

Model: Jeep Grand Cherokee MK 4, WK2 - Years 2010-2021
Part: Instrument cluster
Operation: To reset the oil light on the 2012 Jeep Grand Cherokee.

The procedure to successfully complete the manual reset of the engine oil light on your 2012 Jeep Grand Cherokee is very simple. First, you need to enter the car and reach the driver's seat, then turn on the ignition in diagnostic mode by pressing the appropriate button twice in a row. At this point, press the accelerator pedal three times and fully. When you hear an audible signal, it means that the oil light has been reset correctly, and you can restart the car normally to start driving.


Posted on 27 September 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Grand Cherokee 1998-2004 - Where is the brightness control for the instrument panel of the Jeep Grand Cherokee Mk2 located? Read Answer
    • Grand Cherokee 2004-2010 - What does the 2007 Jeep Grand Cherokee oil light mean? Read Answer
    • Grand Cherokee 2010-2021 - What does the ETC light on the Jeep Grand Cherokee indicate? Read Answer
    • Grand Cherokee 2004-2010 - What does the red engine light on the Jeep Grand Cherokee mean? Read Answer
    • Grand Cherokee 2004-2010 - What does the lightning spy mean in a Jeep Grand Cherokee? Read Answer
    • Grand Cherokee 2004-2010 - What do the spies on the Jeep Grand Cherokee represent? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos