Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Car Radio from the Lancia Phedra

Model: Lancia Phedra MK 1 - Years 2002-2010
Part: Car stereo

As the video shows, you need to lift the two glove compartments, remove the dashboard housing, and raise the anti-rattle (or anti-vibration) cover; this will give you access to the clips holding the dashboard ventilation grille in place. Carefully extract it, which will finally allow you to access the car radio. Now, two small levers need to be fixed to the ends of the car radio, allowing you to pull it out of the guides. Disconnect the connection cables (audio, radio, and power) and finally pull out the car radio. From this point, it is possible to replace or reinsert the car radio.

Updated on 10 March 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Car Radio in the Lancia Phedra
Replacing the Car Radio in the Lancia Phedra
Lancia Phedra (2002-2010 / MK 1) Replacing the car radio is not a complex operation; it only requires the right tools and a bit of skill. It is useful to have a wiring harness for th…
How to Automatically Open Sliding Doors on a Lancia Phedra
Lancia Phedra (2002-2010 / MK 1) This video shows how to automatically open the sliding doors (rear) on a Lancia Phedra. This operation is very simple; follow these steps: press the …
How to Install Roof Bars on a Lancia Phedra?
How to Install Roof Bars on a Lancia Phedra?
Lancia Phedra (2002-2010 / MK 1) Today, we will look at the instructions that will allow us to install roof bars on a Lancia Phedra Van; the installation procedure is quite similar f…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos