Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Lancia
    3. :
  3. Ypsilon
    4. : How to remove the dashboard of the Lancia Ypsilon

Lancia Ypsilon - Video tutorial

Model: Lancia Ypsilon Y2, Ypsilon 2, 843, MK 2 - Years 2003-2011
Part: Dashboard
Operation: How to remove the dashboard of the Lancia Ypsilon

In order to remove the dashboard, or the various parts in the bodywork that make up the dashboard, it is necessary to proceed as follows: access the driver's seat and locate and unscrew the fixing screws of the plastic panel placed around the handbrake, then proceed to remove the screws of the panel under the steering wheel (there are two on both sides and one on the front. Under the dashboard then, to the right of the accelerator pedal, there is a small plastic panel that must be extracted. glove compartment and all around the compartment there are other screws to remove. Finally, proceed to remove the screws on the sides of the air conditioning and radio controls. At that point the entire dashboard will have been removed.


Posted on 4 May 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Ypsilon 2003-2011 - How to reset the airbag warning light on Lancia Ypsilon? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos